公告事项

后退
标题

How to use IX3PRO

发表人 IXNINE(ip:)

日期 2023-12-14

点击数 502

评分 0分  

推荐 推存

内容


<IX3PRO structural Film>




<How to use click-on when wearing goggles>



1. Pressing the groove at the bottom of the frame (both sides) creates a gap between the frame and the lens.


2. You can hold the lens frame and raise it to 45 degrees.


3. If you want to lift up the lens to 90 degrees, you can conveniently raise it by holding the click-on part at the top of the frame (the part where the frame and the lens are in contact).






<How to replace the IX3PRO strap>



1. Pressing the grooves (one of two) on either side of the lower part of the frame creates a gap between the frame and the lens.


2. Press the center click-on part at the end of the lens frame and at the top of the frame to lift it up to 90 degrees.


3. Pulling the straps on the inside of both ends of the frame while pushing them out releases the straps.


Tip. If you pull it diagonally, it comes off easily, and even if you open the holes at both ends of the frame slightly, it separates well.






<How to replace the IX3PRO lens>


.

1. Pressing the grooves (one of two) on either side of the lower part of the frame creates a gap between the frame and the lens.


2. Lift the lens up to 45 degrees and pull it aside to separate the lens.

* Remove the lens only at 45 degrees.


3. After placing the lens to be replaced on the frame, adjust and press the top of the frame and the click-on part of the lens.


附件

密码
修改

如需修改或删除,请填写密码。

留言修改

姓名

密码

内容

/ byte

修改 取消
密码
确认 取消

WORLD SHIPPING

PLEASE SELECT THE DESTINATION COUNTRY AND LANGUAGE :

GO
Close